Table of Contents
Advertisement
2600-00CTEIGAA
Ver.
ANNEX C. Assembling connector
Check for Working with the Heat Shrink Tube
- If you work without holding one end of the heat shrink tube, the location of the
- The connector part where 1/2 in. and 7/8 in. feeder line are connected must be
- If jelly does not appear on the end of the heat shrink tube, it may mean that it is
C-20
4.0
heat shrink tube may be changed. Therefore, make sure to hold one end of it
when applying heat.
the center of the heat shrink tube. After inserting the heat shrink tube, mark the
center part.
not shrunk properly. Apply heat until jelly appears using a heating gun.
Jelly
© SAMSUNG Electronics Co., Ltd.
Advertisement
Table of Contents
