Din Type-Male (1/2 In. Feeder Line - Samsung Smart MBS RRH-P4 Installation Manual

2600-00CTEIGAA Ver.
ANNEX C. Assembling connector
C.6 Din type-male (1/2 in. Feeder Line)
Below is the method for assembling the Din type-male connector to the 1/2 in. feeder line.
1) The components of the Din type-male are an Din type-male body, a pin , an insert ring, a clamp nut,
o-ring and a heat shrink tube, and it is assembled using the wire stripper, trimming tool, wrench, etc.
Din type-male Body
2) Straighten the cable, then, using a suitable tool, strip it to the connector's wire strip length.
When cutting the sheath, hold the cable firmly with one hand and cut the cable pulling the cutting tool
inwards with the other hand. Gently rotate the tool several times (do not pull it too hard), so that the
internal copper line is not damaged.
3) Using a cutter, cut the sheath from the stripped edge to the end of the cable and completely strip the sheath.
4) Insert the O-ring, clamping nut, insert ring, pin and Din type-male body into the stripped feeder line in this
order.
Figure C.12 Assembling the Din type-male Connector (1/2 in. Feeder Line) (1)
C-12
4.0
Pin
Insert Ring
Clamping Nut
O-Ring
Cutting Tool
Cutter
Feeder Line
Feeder Line
Heat Shrink Tube
© SAMSUNG Electronics Co., Ltd.