Samsung Smart MBS RRH-P4 Installation Manual page 123

2600-00CTEIGAA Ver.
© SAMSUNG Electronics Co., Ltd.
4.0
Figure C.7 Assembling the TNC-male connector (2)
Smart MBS RRH-P4 Installation Manual/Ver.3.0
5) Push the TNC male body into the end of the cable
until it is solidly inserted to the pin connection part
of the TNC male body. Make the shield overlap
over the TNC male body. Then pull out the clamp
ring and reset it to the original position to make the
remaining shield folded.
6) Cut off the folded remaining shield using a cutting
device so that it does not protrude outside when
the clamp ring is inserted.
After arranging the shield, push up the clamp ring
toward a connector until the entire shield is covered.
7) Using a compressor and hexagonal dies,
pressurize the clamp ring to fix the cable and
connector.
8) Lift the heat shrink tube up to the connection point
on the connector, and shrink the heat shrink tube
using a heating gun.
C-7