Samsung Smart MBS RRH-P4 Installation Manual page 129

2600-00CTEIGAA Ver.
5) Tighten firmly the clamping nut and Din type-male body inserted to the 1/2 in. feeder line using a wrench.
The recommended torque for tightening the clamping nut and Din type-male body is 306~510 lbf·ft
(30~50 N.m). (Note that it should only be fastened by rotating the clamping nut with the external body in a
fixed and stable position.)
Din type-Male Body
6) Insert the heat shrink tube (28 mm/10 cm) to the 1/2 in. feeder line fitted with the Din type-male
connector; and shrink the heat shrink tube inserted into the feeder line using a heating gun.
- Heat shrink tube: Φ 1.1 in., 3.94 in. (Φ 28 mm, 100 mm)
Figure C.13 Assembling the Din type-male Connector (1/2 in. Feeder Line) (2)
Checking to carry out when assembling the Din type-male connector
The shape, tool and assembly method may differ depending on the connector
type and manufacturer. Make sure to check the user manual provided by the
manufacturer before assembling.
© SAMSUNG Electronics Co., Ltd.
4.0
Heat Shrink Tube
Smart MBS RRH-P4 Installation Manual/Ver.3.0
Spanner (Maintaining fixing status)
Clamping Nut
Heating Gun
C-13