Alarms Generated By The Basic Control Panel - ABB ACS355 User Manual

Alarms generated by the basic control panel

The basic control panel indicates control panel alarms with a code, A5xxx.
ALARM CODE CAUSE
5001 Drive is not responding.
5002 Incompatible
communication profile
5010 Corrupted panel parameter
backup file
5011 Drive is controlled from
another source.
5012 Direction of rotation is
locked.
5013 Panel control is disabled
because start inhibit is
active.
5014 Panel control is disabled
because of drive fault.
5015 Panel control is disabled
because local control
mode lock is active.
5018 Parameter default value is
not found.
5019 Writing non-zero
parameter value is
prohibited.
5020 Parameter or parameter
group does not exist or
parameter value is
inconsistent.
5021 Parameter or parameter
group is hidden.
5022 Parameter is write
protected.
5023 Parameter change is not
allowed when drive is
running.
5024 Drive is executing a task.
5025 Software is being uploaded
or downloaded.
5026 Value is at or below
minimum limit.
5027 Value is at or above
maximum limit.
5028 Invalid value
WHAT TO DO
Check panel connection.
Contact your local ABB representative.
Retry parameter upload.
Retry parameter download.
Change drive control to local control mode.
Enable change of direction. See parameter
1003 DIRECTION.
Start from panel is not possible. Reset
emergency stop command or remove 3-wire
stop command before starting from panel.
See section 3-wire macro
parameters 1001 EXT1
EXT2 COMMANDS and
SEL.
Reset drive fault and retry.
Deactivate local control mode lock and retry.
See parameter 1606 LOCAL
Contact your local ABB representative.
Only parameter reset is allowed.
Contact your local ABB representative.
Contact your local ABB representative.
Parameter value is read-only and cannot be
changed.
Stop drive and change parameter value.
Wait until task is completed.
Wait until upload/download is complete.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Fault tracing 341
on page 113 and
COMMANDS, 1002
2109 EMERG STOP
LOCK.