ABB ACS355 User Manual page 70

70 Start-up, control with I/O and ID run
Change parameter
the new setting by pressing
If you want to monitor actual values during the ID
run, go to the Output mode by pressing
repeatedly until you get there.
Press to start the ID run. The panel keeps
switching between the display that was shown
when you started the run and the alarm display
presented on the right.
In general, it is recommended not to press any
control panel keys during the ID run. However, you
can stop the ID run at any time by pressing
After the ID run is completed, the alarm display is
not shown any more.
If the ID run fails, the fault display presented on
the right is shown.
ID RUN WITH THE ASSISTANT CONTROL PANEL
Change parameter
the new setting by pressing
If you want to monitor actual values during the ID
run, go to the Output mode by pressing
repeatedly until you get there.
Press to start the ID run. The panel keeps
switching between the display that was shown
when you started the run Run and the alarm
display presented on the right.
In general, it is recommended not to press any
control panel keys during the ID run. However, you
can stop the ID run at any time by pressing
ID RUN WITH THE BASIC CONTROL PANEL
9910 ID RUN
.
9910 ID RUN
SAVE
.
to 1 (ON). Save
LOC
LOC
LOC
OUTPUT
LOC
.
LOC
to 1 (ON). Save
EXIT
.
9910
PAR
1
PAR SET
00
.
A2019
F0011
REM PAR EDIT
9910 ID RUN
ON
[1]
CANCEL 00:00 SAVE
LOC 50.0Hz
0 0 Hz .
0 0 A .
0 0 % .
DIR 00:00 MENU
LOC ALARM
ALARM 2019
ID RUN
00:00
FWD
FWD
Hz
FWD
FWD
FWD