How To Perform A Manual Start-Up - ABB ACS355 User Manual

How to perform a manual start-up

For the manual start-up, you can use the basic control panel or the assistant control
panel. The instructions below are valid for both control panels, but the displays shown
are the basic control panel displays, unless the instruction applies to the assistant
control panel only.
Before you start, ensure that you have the motor nameplate data on hand.
Apply input power.
The basic control panel powers up into the Output
mode.
The assistant control panel asks if you want to run
the Start-up assistant. If you press
up assistant is not run, and you can continue with
manual start-up in a similar manner as described
below for the basic control panel.
MANUAL ENTRY OF START-UP DATA (parameter group 99)
If you have an assistant control panel, select the
language (the basic control panel does not
support languages). See parameter
values of the available language alternatives.
For instructions on how to set parameters with the
assistant control panel, see section
panel on page 87.
Select the motor type (9903).
• 1 (AM): Asynchronous motor
• 2 (PMSM): Permanent magnet motor.
Setting of parameter
example of parameter setting with the basic control
panel. You find more detailed instructions in section
Basic control panel
1. To go to the Main menu, press
shows OUTPUT; otherwise press
until you see MENU at the bottom.
2. Press keys
press .
3. Find the appropriate parameter group with keys
/
4. Find the appropriate parameter in the group with
keys /
POWER-UP
Assistant control
9903 is shown below as an
on page 75.
/ until you see "PAr", and
and press .
.
Start-up, control with I/O and ID run 61
REM
OUTPUT
REM
EXIT
, the Start-
REM
9901 for the
REM
if the bottom line
repeatedly
REM
REM
REM
REM
00
.
CHOICE
Do you want to
use the start-up
assistant?
Yes
No
00:00
EXIT
PAR EDIT
9901 LANGUAGE
ENGLISH
[0]
CANCEL 00:00 SAVE
9903
PAR
rEF
MENU
-01-
PAR
9901
PAR
9903
PAR
Hz
FWD
OK
FWD
FWD
FWD
FWD
FWD