ABB ACS355 User Manual page 206

206 Actual signals and parameters
All parameters
No. Name/Value
DI4(INV)
DI1,2(INV)
DI2,3(INV)
DI3,4(INV)
DI4,5(INV)
1606 LOCAL LOCK
NOT SEL
DI1
DI2
DI3
DI4
DI5
ON
COMM
DI1(INV)
DI2(INV)
DI3(INV)
DI4(INV)
DI5(INV)
1607 PARAM SAVE
DONE
Description
See selection DI1(INV).
User parameter set selection through inverted digital inputs
DI1 and DI2. 1 = DI inactive, 0 =DI active.
DI1 DI2 User parameter set
1 1 User parameter set 1
0 1 User parameter set 2
1 0 User parameter set 3
See selection DI1,2.
See selection DI1,2.
See selection DI1,2.
Disables entering local control mode or selects the source
for the local control mode lock signal. When local lock is
active, entering the local control mode is disabled
(LOC/REM key of the panel).
Local control is allowed.
Local control mode lock signal through digital input DI1.
Rising edge of digital input DI1: Local control disabled.
Falling edge of digital input DI1: Local control allowed.
See selection DI1.
See selection DI1.
See selection DI1.
See selection DI1.
Local control is disabled.
Fieldbus interface as the source for the local lock, ie control
word 0301 FB CMD WORD 1
sent by the fieldbus controller through the fieldbus adapter
or embedded fieldbus (Modbus) to the drive. For the control
word bits, see section
320.
Note: This setting applies only for the DCU profile.
Local lock through inverted digital input DI1. Rising edge of
inverted digital input DI1: Local control allowed. Falling edge
of inverted digital input DI1: Local control disabled.
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
Saves the valid parameter values to the permanent
memory.
Note: A new parameter value of a standard macro is saved
automatically when changed from the panel but not when
altered through a fieldbus connection.
Saving completed
bit 14. The control word is
DCU communication profile
Def/FbEq
-4
-7
-8
-9
-10
NOT SEL
0
1
2
3
4
5
7
8
on page
-1
-2
-3
-4
-5
DONE
0