C-Tick Marking; Tüv Nord Safety Approved Mark; Rohs Marking; Compliance With The Machinery Directive - ABB ACS355 User Manual

376 Technical data

C-Tick marking

See the type designation label for the valid markings of your drive.
C-Tick marking is required in Australia and New Zealand. A C-Tick mark is attached
to the drive to verify compliance with the relevant standard (IEC 61800-3:2004 –
Adjustable speed electrical power drive systems – Part 3: EMC product standard
including specific test methods), mandated by the Trans-Tasman Electromagnetic
Compatibility Scheme.
The Trans-Tasman Electromagnetic Compatibility Scheme (EMCS) was introduced
by the Australian Communication Authority (ACA) and the Radio Spectrum
Management Group (RSM) of the New Zealand Ministry of Economic Development
(NZMED) in November 2001. The aim of the scheme is to protect the radio frequency
spectrum by introducing technical limits for emission from electrical/electronic
products.
For fulfilling the requirements of the standard, see section Compliance with
EN 61800-3:2004 on page 373.
TÜV NORD Safety Approved mark
The presence of the TÜV NORD Safety Approved mark verifies that the drive has
been evaluated and certified by TÜV NORD according to the following standards for
the realization of the Safe torque off function (STO): IEC 61508-1:1998,
IEC 61508-2:2000; SIL3, IEC 62061:2005 and ISO 13849-1:2006. See Appendix:
Safe torque off (STO).

RoHS marking

The RoHS mark is attached to the drive to verify that the drive follows the provisions
of the European RoHS Directive. RoHS = the restriction of the use of certain
hazardous substances in electrical and electronic equipment.

Compliance with the Machinery Directive

The drive is intended to be incorporated into machinery to constitute machinery
covered by Machinery Directive (2006/42/EC) and does therefore not in every
respect comply with the provisions of the directive. For more information, see the
Declaration of Incorporation by ABB Drives.