Transistor Output; Settings; Diagnostics; Actual Signals - ABB ACS355 User Manual

134 Program features

Transistor output

The drive has one programmable transistor output. The output can be used either as
a digital output or frequency output (0...16000 Hz). The update time for the
transistor/frequency output is 2 ms.

Settings

Parameter
Group 18 FREQ IN & TRAN OUT
8423

Diagnostics

Actual signal
0163
0164

Actual signals

Several actual signals are available:
• Drive output frequency, current, voltage and power
• Motor speed and torque
• Intermediate circuit DC voltage
• Active control location (LOCAL, EXT1 or EXT2)
• Reference values
• Drive temperature
• Operating time counter (h), kWh counter
• Digital I/O and analog I/O status
• PID controller actual values.
Three signals can be shown simultaneously on the assistant control panel display
(one signal on the basic control panel display). It is also possible to read the values
through the serial communication link or through the analog outputs.
Settings
Parameter
1501
1808
Group 32 SUPERVISION
Group 34 PANEL DISPLAY
Additional information
Transistor output settings
Transistor output control with Sequence programming
Additional information
Transistor output status
Transistor output frequency
Additional information
Selection of an actual signal to AO
Selection of an actual signal to frequency output
Actual signal supervision
Selection of an actual signals to be displayed on the
control panel