How To Start Up The Drive Without A Control Panel - ABB ACS355 User Manual

60 Start-up, control with I/O and ID run
• Check the installation. See the checklist in chapter
57.
How you start up the drive depends on the control panel you have, if any.
• If you have no control panel, follow the instructions given in section
up the drive without a control panel
• If you have a basic control panel (ACS-CP-C), follow the instructions given in
section How to perform a manual start-up
• If you have an assistant control panel (ACS-CP-A, ACS-CP-D), you can either
run the Start-up assistant (see section
66) or perform a manual start-up (see section
on page 61).
The Start-up assistant, which is included in the assistant control panel only, guides
you through all essential settings to be done. In the manual start-up, the drive
gives no guidance; you go through the very basic settings by following the
instructions given in section

How to start up the drive without a control panel

Apply input power and wait for a moment.
Check that the red LED is not lit and the green LED is lit but not blinking.
on page 60.
How to perform a guided start-up
How to perform a manual start-up
POWER-UP
The drive is now ready for use.
Installation checklist
on page 61.
How to perform a manual start-up
on page
How to start
on page
on page 61.