Configuring Mimic Tours; Programming A Mimic Tour; Running A Mimic Tour; Stopping A Mimic Tour - Honeywell ACUIX Installation And Configuration Manual

Configuring Mimic Tours

Task/Action (with Default)

Programming a Mimic Tour

1. Select 6 Function Programming

2 Program a Tour, or

• 83 Preset to create mimic tour 1.

• 84 Preset to create mimic tour 2.

• 85 Preset to create mimic tour 3.
2. During the 120 second countdown, pan and tilt the dome and
adjust the lens zoom setting as required.
3. To end the programming mode, either wait for the countdown to
reach 0 or send a 86

Running a Mimic Tour

1. Select the applicable preset number or use the function
programming menu:

• 76 Preset to run a mimic tour between 1 and 16

• 80 Preset to run mimic tour 1.

• 81 Preset to run mimic tour 2.

• 82 Preset to run mimic tour 3.
• Select 6 Function Programming

Menu 1 Run a Tour.

Stopping a Mimic Tour

Stop any mimic tour by manually controlling the dome or by sending the dome to a preset, preset tour, or another
mimic tour command.

Deleting a Mimic Tour

• Select 6 Function Programming

3 Delete Mimic Tour
number to delete.
Document 800-05662 Rev C
06/10
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Caution Continuous mimic tour operation (no times with zero motion and auto
focus set on pan, tilt, and zoom) is not recommended. Continuous
operation results in increased zoom lens wear and maintenance expense.
Note Remember you access the OSD by pressing 90

1 PTZ Mimic Tour Menu

Preset.

1 PTZ Mimic Tour

1 PTZ Mimic Tour Menu

Enter the pre programmed tour

Preset.
Notes
The dome stores the commands in the
order performed during the 120 second
tour (two minutes).
Pelco protocols only: You can run mimic
tours 1 to 3 although the Pelco keyboard
has a key labeled Pattern that sends out a
command to perform Pattern tour 0. The
ACUIX mimic tours numbered 1, 2, and 3
are mapped to Pelco's Pattern tours
numbered 0, 1, and 2, respectively.
Existing programming does not have to
be deleted to be reprogrammed. You can
edit existing mimic tour coordinates by
following the programming procedures.
97