Figure 3-12 Rugged Housing Bracket Adjustment - Honeywell ACUIX Installation And Configuration Manual

Document 800-05662 Rev C
06/10
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Note To change the bracket orientation, loosen and remove the two bolts that
secure the bracket to the housing and slide the bracket along the slot to
remove it from the housing.
5. If required, secure an installer supplied safety cable to a building support structure.
Attach the safety cable (from the building support structure) to the mounting bracket
by:
a. Routing the safety around the mounting bracket, then
b. Through a hole in the side of the mounting bracket, and then
c. Through the other side of the looping sleeve, and finally
d. Crimping the looping sleeve to secure the safety cable.
Figure 3-12 Rugged Housing Bracket Adjustment
49