Honeywell ACUIX Installation And Configuration Manual page 57

Document 800-05662 Rev C
06/10
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
4. Loosen the screws on the terminal strip and insert the 24 VAC power wires, data
wires, video wires (if UTP is selected) and contact wires in the correct positions on
terminal strips J1, J4, J6, and J7. See
54.
Ensure the yellow labeled terminal strip is plugged into the yellow labeled connector
and the white labeled terminal strip is plugged into the white labeled connector.
Note Both terminal strips J1 and J6 accept 26–12 AWG wire. If larger or smaller
field-run wire is required, a 26–12 AWG wire must be spliced onto the field
wire for insertion into the terminal strip.
Note Ensure the correct connections are made with terminal strip J6 - RS485 data
(-) and data (+) otherwise polarity can be an issue.
Note You can connect the data cable shield to Pin 3 (SH) on terminal strip J1. Use
this connection for looping the shield through to the next dome in the
daisychain. It is not connected to the housing interface board.
5. Tighten the screw on the terminal strip to secure the wires.
6. Connect incoming coaxial cable to coaxial pigtail on the housing interface board.
Tighten the screw on the terminal strip to secure the wiring.
7. Plug the terminal strips into the respective connectors on the interface board. If you
are using a coaxial cable for video, connect the field run coaxial cable to J3.
Note When connecting field wiring, connect to either J3 or J7, not to both at the
same time.
8. If applicable, secure the wires from the terminal strip and BNC connector together
with a wire tire to ensure the cabling does not prevent the secure closure of the
housing and lower dome.
9. Feed extra wire and cable up through the hole in the housing and route it so that it
doesn't interfere with the scan assembly when it is inserted.
Terminal Block and PIN Connections, page
57