Turning The -5 Tilt Limit On Or Off; Finding The Mechanical Home On Startup; Turning The Pan Offset On Or Off; Setting The Pan Offset - Honeywell ACUIX Installation And Configuration Manual

Task/Action (with Default)
Turning the -5 Tilt Limit ON or OFF
1. Select 3 Control Options

–5 Tilt Limit
2. Select ON to position the unit tilt to 5 above horizontal or OFF
(default).

Finding the Mechanical Home on Startup

1. Select 3 Control Options
Find Home on Startup
2. Select:
• OFF (default) to set the unit to find home when powered up
and the dome performs a control command.
• ON to set the dome to find the mechanical home (or index)
position after an initial startup delay of 15 seconds.
If you selected ON, the message Extreme Caution: This
3.
will cause the scan to move immediately on
startup... displays.
• Select Y (yes) to continue or N (no) to cancel.

Turning the Pan Offset ON or OFF

Select 3 Control Options
 
Offset 1 Pan Offset

Setting the Pan Offset

1. Select 3 Control Options

Pan Offset 1 Pan Offset

2. Press 0 Preset.
3. Position the dome where preset 0 is expected to be. If it does
not go to the previously known position for preset 0, the offset
function cannot be used.
4. Select 3 Control Options

Pan Offset 2 Set Pan Offset.
5. Test the setting. Reposition the unit, and select 0
confirm it returns to the position programmed.
Document 800-05662 Rev C
06/10
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide

4 Set Pan and Tilt Options

4 Set Pan and Tilt Options


4 Set Pan and Tilt Options
ON or OFF (default).

4 Set Pan and Tilt Options

ON.

4 Set Pan and Tilt Options
Notes

4 Allows the camera to tilt 5 degrees above
horizontal.

5 When a privacy zone is enabled, no video
is shown during the finding home process
and privacy zones are not recognized
until the dome reaches home. Once the
dome finds home, a picture can be
viewed on the monitor unless a privacy
zone overlaps with this home setting.

6 Pan Pan Offset is password protected. It can
only be enabled by authorized personnel
with Administrator privileges.

6 For all protocols, preset 0 is used to
define the location of the pan setting; you
must know the original positioning of
preset 0 to complete these steps.
The pan offset feature is useful when a
new scan assembly is installed in a dome
and you want to transfer programming

6
from the previous scan assembly to the
new dome using the upload/download
 feature.
Preset to
The pan offset password protection
prevents unauthorized users from
viewing privacy zone areas.
79