Step 4: Learn How To Use The Special Presets - Honeywell ACUIX Installation And Configuration Manual

No. Button Use
6. mode Press to toggle between DVR and MUX modes. To toggle between PTZ mode ON and
OFF, press and hold Fn, then press the mode button to select PTZ.
Note
7. wash •
wipe
•
aux
•
lock
•
Note
Caution
8. camera •
preset
•
sequence
•
monitor
•
9. auto 180 •
autopan
•
10. Fn •
•

Step 4: Learn How to Use the Special Presets

Document 800-05662 Rev C
06/10
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Table 4-2 HJZTP Controller Functions
The PTZ domes can be controlled while the controller is in any mode (for example,
MUX, DVR, or PTZ).
Press and hold wash to toggle ON and OFF and insert a line.
Press wipe to toggle ON and OFF and delete a line.
Press aux as part of the sequence to open the OSD or while in list menus, to display
the next page of items.
Press lock to exit OSD and LCD menus and return the dome and controller to normal
operation.
In the event pressing lock does not exit the OSD and LCD menus, press F6
repeatedly until you are completely out of the menus. Each time you press F6 you
back up the menu structure one level (that is, to the previous screen).
If you press F6 four times after you are out of the menus, the dome will
reset.

Press a dome number

Press preset [preset number] to access presets and tours.
Press sequence to send 'S' to the dome and save settings.
Pressing a number (1 to 4) followed by monitor selects that auxiliary monitor for
control by the controller (the spot monitor number is displayed on the LCD). If you
press monitor without first entering a number, the controller goes back to the main
monitor (MAIN displays on the LCD).
Press auto 180 to view a person walking underneath the dome; pan the dome 180 at
the maximum speed.
Autopan is used with presets and tours.
To return to manual control, press and hold Fn, then press F6 (menu). The 'return to
manual' command is used to cancel automatic dome actions.
To return to mechanical home, press and hold Fn, then press F1, to send the dome to
its mechanical home position.
There are several special presets reserved for controlling and programming the dome.
Depending on the protocol, approximately 150 presets are available for custom
programming. Presets 72–99 are reserved for the available special presets listed in
Table 4-3 and described in this guide.
camera to select that dome to display on the monitor.
67