Introduction To The Acuix Ptz Dome; About Using This Guide; Installation And Configuration Overview - Honeywell ACUIX Installation And Configuration Manual

Introduction to the ACUIX PTZ Dome

About Using This Guide

Installation and Configuration Overview

Document 800-05662 Rev C
06/10
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
In this section:
• About Using This Guide, page
• About the ACUIX Analog PTZ
• ACUIX Hardware Terminology, page
• Configuration Options, page
• ACUIX Feature Descriptions, page
• Camera Model Dependent Features: EIS, TDN and
A complete ACUIX™ system installation is a multi-step process and depends on individual
hardware configurations.
A typical installation has these steps:
1. Set the switches on the housing interface board.
2. Set the switches on the scan assembly circuit board.
3. Install the mount, adapter and/or bracket.
4. Install the housing.
5. Connect the wiring to the housing interface board.
6. Install the scan assembly.
7. Install the lower dome.
8. Configure the dome. If applicable, continue setting up and configuring other custom
settings including privacy zones and preset tours. If required or applicable, proceed
to user configurations based on other hardware, for example, a DVR.
17
Dome, page 18
19
20
21
WDR, page
1
24
17