Installing Indoor Or Outdoor Pendant Mounts And Adapters; Figure 3-7 Wall Mount Dimensions - Honeywell ACUIX Installation And Configuration Manual

Installation

Installing Indoor or Outdoor Pendant Mounts and Adapters

4.1" (105.0 mm)
5.5" (140.0 mm)
44
The indoor and outdoor pendant housing has optional mounts and adapters available:
• Wall mount (HDXWM2)
• Pole mount adapter (HDXPMA1)
• Corner adapter (HDXCMA1)
• Parapet or roof mount (HDPRM2)
• Ceiling mount (HDCM1)
Installing a Wall Mount and Optional Pole or Corner Adapters
The wall mount is designed specifically for the ACUIX dome and can be mounted directly
to a vertical load-bearing surface. It supports up to 25 pounds (11.7 kg). The optional
corner and pole adapters can be used with the wall mount or with the rugged bracket.
Figure 3-7 Wall Mount Dimensions
1. Route field wiring as required through:
a. The wall, then
b. (Optional) If installing with a corner adapter or pole mount adapter, also route
the field wiring through the corner or pole adapter hole, then
c. Through the back of the mount between the mounting bolts/screws, then
d. Through the pendant housing wiring access hole.
If running a surface mounted conduit, you can also route the wiring through the 3/4"
(19 mm) wiring access hole near the base of the mount arm (see
For all installations, approximately one foot (0.3 m) of cable must extend past the
mount.
2. (Optional) If you are installing the wall mount with a corner adapter (HDXCMA1) or
pole mount adapter (HDXPMA1) then:
Pole Adapter
Secure the pole mounting bracket to the pole using hardware specifically designed
for the surface/material. There are four cutouts (two on each side), 0.24" x 0.75" (6
mm x 19 mm), to accommodate straps to secure the pole mounting bracket to a
pole. See Figure 3-8.
14.7"(373 mm)
0.75" dia. (19.0 mm) wiring access
hole for surface mounted conduit
Figure 3-7).