Honeywell ACUIX Installation And Configuration Manual page 133

Task/Action (with Default)
4. Select 2 Clear Error Logs.
5. Select 3 Run Diagnostics.
• Select Find Home to determine if the dome has found
home or if there is a Pan or Tilt homing error.
• Select Check Supply Voltage to see the status of the 15V
power supply used to operate the camera and the 3.3V
supply used to operate the PC boards. The status will show
as PASS or FAIL.
Displaying System Information
 
1. Press 75 Preset
The Password Settings screen opens.
2. Select 5 Firmware Info.
Various diagnostic information displays on the monitor as in the
screen below.
Document 800-05662 Rev C
06/10
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
enter the password (1000 = default).
Notes
All error counts in the error log table are
set to zero.
Run Diagnostics allows you to see if the
dome has found Home or to check the
supply voltage for the camera and the PC
boards.
This is generally only used by technicians
or for troubleshooting.
133