Flashback; Mimic Tours; Presets - Honeywell ACUIX Installation And Configuration Manual

Introduction to the ACUIX PTZ Dome

Flashback

Mimic Tours

Presets

22
Use the Flashback feature to toggle between two saved positions and quickly return to a
scene of interest.
Flashback is available using a controller. When you press Flashback, it saves the scene
(Scene A) as a Flashback. When you move to the next scene (Scene B) and press
Flashback again, it saves Scene B and returns the dome to Scene A. If the operator
presses Flashback a third time (without manually moving to a new scene), the dome
returns to Scene B. The dome only saves and toggles between two scenes at a time,
except when Flashback is used during a preset tour.
A mimic tour saves the pan, tilt, and zoom commands performed by a user. When a mimic
tour is started, the dome replays the saved commands. A mimic tour is useful when
operators are interested in scanning slowly to a particular area on a regular basis. You
can program up to 16 mimic tours up to 120 seconds (two minutes) each.
Note Presets are called PreShots on some controllers.
The ACUIX supports up to 150 custom presets when using IntelliBus
protocols; 132 with MAXPRO-mode, or 99 with VCL protocol. There are two types of
presets: (1) A special preset or shortcut to a function, for example, opening the OSD
menus and (2) an operator created/programmed set of commands (pan, tilt, zoom, focus,
and iris setting). The programmed preset is recalled in response to a contact or set as the
default function when the dome is idle for a specified time. Other facts about presets
include:
• Individual presets can also be part of preset tours.
• Each preset can have a 24-character alphanumeric name.
• With the ACUIX analog domes, presets are dependent on the protocol being used.
• By default, the preset name/number for configured presets displays in the top left
corner of the screen.
TM
or Diamond