Fujitsu Siemens Computers pmn User Manual page 514

Message lines
SXTF005 NOTICE: dtv_iread(<maj,min>: ino=<ino>): root directory stale!
SXTF005 NOTICE: dtv_rdlookup(<maj,min>: ino=<ino>): root directory stale!
Meaning
When reading in a file or searching the root directory on a DTV client system (e.g. ICP),
it was determined that the specified file has been deleted or renamed at some point.
As a result, the root directory is reloaded.
SXTF005 NOTICE: dtv_irwclose(<maj,min>: ino=<ino>): cannot sync data to disk
SXTF005 NOTICE: dtv_irwclose(<maj,min>: ino=<ino>): cannot sync inode to disk
Meaning
The (meta)data of a volume file could not be written to the hard disk when closing the file.
As a result, operator message DTV(# 6) is output.
Response
Rewrite the volume.
SXTF005 NOTICE: dtv_iflush(<maj,min>: ino=<ino>): i/o error
SXTF005 NOTICE: dtv_rdflush(<maj,min>): i/o error
SXTF005 NOTICE: dtv_sbflush(<maj,min>): i/o error
SXTF005 NOTICE: dtv_bp0flush(<maj,min>): i/o error
SXTF005 NOTICE: dtv_auhflush(<maj,min>): i/o error
Meaning
I/O error when writing the following metadata:
iflush ::
rdflush ::
sbflush ::
bp0flush ::
auhflush :: Allocation unit headers (AU BlockMaps) - " -
As a result, operator message DTV(# 3) is output.
Response
If these error messages recur, determine the source of the error and correct it. Notify
maintenance staff if necessary.
Bulletins are issued during startup of the DTV if the "verbose" mode has been activated.
SXTF006 dtv_binit: allocated <n> contiguous memory chunks of size <size>
SXTF006 dtv_binit: *** <n> chunks non contiguous
SXTF006 dtv_binit: iocache=<addr>(<size>MB)
SXTF006 dtv_binit: bhpool=<addr>(<size>KB,<n> free)
Meaning
For information purposes only and only if "verbose" = on.
Response
None. If, however, memory problems occur later, notify maintenance staff.
514
Inode of a file
Root directory of the file system
Superblock of the file system
Superblock, RootInode, CoreBlockMap of the file system
Explanation of console messages
U41117-J-Z125-7-76