Table of Contents
Advertisement
Chapter 7
Using the FAX Passthrough Feature
Configuring the Cisco ATA 186 for Fax Mode on a Per-Call Basis
Configuring the Cisco Gateway for FAX Mode
OL-1267-01
The settings for FAX mode are:
AudioMode—Set to 0xXXXX0012 for line 1, or 0x0012XXXX for line 2,
•
(X = don't care). The value 0x0012 means we disable fax detection, disable
G.711 silence suppression and use G711 only on this line.
If you want to activate Fax Mode on a per-call basis, configure bit 15
(line 1—mask 0x8000) and Bit 31 (line 2—mask 0x8000000)—0 (1) to set the
default to enable (disable) FAX mode on a per call basis.
To activate this call in the U.S., from the Fax machine enter *99 (default) and then
the telephone number to which you want to send the Fax. The next call will
automatically revert to normal mode.
To activate this call in Sweden., from the Fax machine enter *99# (default) and
then the telephone number to which you want to send the Fax. The next call will
automatically revert to normal mode.
On the Cisco Gateway, disable both FAX relay and FAX Passthrough with the
following commands:
no fax relay
no modem passthrough
Cisco ATA 186 Installation and Configuration Guide
About FAX Mode
7-5
Advertisement
Table of Contents
Troubleshooting
