About Call Waiting; Call Waiting In The U.s; Call Waiting In Sweden - Cisco ATA186-I1 Installation And Configuration Manual

Chapter 5 Configuring Supplementary Services
Step 3
Step 4
Step 5
Step 6

About Call Waiting

Call Waiting in the U.S.

Call Waiting in Sweden

OL-1267-01
Dial the second person and speak normally when that person answers.
Perform a second hook flash and press 2 on the telephone handset to get back to
the first person. You can continue to switch back and forth between the two
callers.
To conference with both callers at the same time, perform a hook flash and press
3 on the telephone handset. Once you conference all three callers, the only way to
drop a caller is for that caller to hang up.
(Optional) To conference in additional callers, the last person called with a
Cisco ATA 186 can call an additional person, and so on. This is known as
"daisy-chaining."
This section describes the Call Waiting feature.
If someone calls you while you are speaking on the telephone, you can answer by
performing a hook flash. You cannot conference in all 3 callers, but the first
person you called could call someone else and "daisy-chain" them in. If there is
no answer after one minute, the caller will hear 3 beeps and a busy signal.
When the Cisco ATA 186 is configured to use Call Waiting by default, press *70
to disable Call Waiting for the duration of the next call.
If someone calls you while you are speaking on the telephone, you can answer by
performing a hook flash and pressing 2 to answer or 3 to conference them with
the person you are already speaking to. You can also press 3 later during the call
to conference.
Performing a hook flash and pressing 1 hangs up the first caller and answers the
second call. If there is no answer after one minute, the caller will hear 3 beeps and
a busy signal.
Cisco ATA 186 Installation and Configuration Guide
Common Supplementary Services
5-3