Overview Of Configuring And Installing Cisco Unified Ip Phones; Configuring Cisco Unified Ip Phones In Cisco Unified Communications Manager - Cisco CP-3911 - Unified SIP Phone 3911 VoIP Administration Manual

Overview of Configuring and Installing Cisco Unified IP Phones

Overview of Configuring and Installing Cisco
Unified IP Phones
Configuring Cisco Unified IP Phones in Cisco Unified
Communications Manager
Cisco Unified SIP Phone 3911 Administration Guide for Cisco Unified Communications Manager
1-10
When deploying a new IP telephony system, system administrators and network
administrators must complete several initial configuration tasks to prepare the
network for IP telephony service. For information and a checklist for setting up
and configuring a complete Cisco Unified IP telephony network, refer to the
"System Configuration Overview" chapter in Cisco Unified Communications
Manager System Guide.
After you have set up the IP telephony system and configured system-wide
features in Cisco Unified Communications Manager, you can add IP phones to the
system.
The following topics provide an overview of procedures for adding
Cisco Unified IP Phones to your network:
Configuring Cisco Unified IP Phones in Cisco Unified Communications
•
Manager, page 1-10
Installing Cisco Unified IP Phones, page 1-14
•
To add phones to the Cisco Unified Communications Manager database, you can
use:
Auto-registration
•
Cisco Unified Communications Manager Administration
•
• Cisco Unified Communications Manager Bulk Administration (BAT)
BAT and the Tool for Auto-Registered Phones Support (TAPS)
•
For more information about these choices, see the
Unified Communications Manager Database" section on page
Chapter 1 An Overview of the Cisco Unified IP Phone
"Adding Phones to the Cisco
2-9.
OL-14029-01