Call Progress Tone Parameters and
Defaults
This Appendix provides detailed information on the call progress tone parameters
and defaults you can use to provision your Cisco ATA 186.
Call Progress Tone Parameters
The call progress tone parameter is used to set the tone and frequency of the call
progress tone. This value is expressed as an integer. You cannot configure the call
progress tone by using the IVR mode. You must use the web interface or
autoprovisioning.
The default is the recommended U.S. value of 2,4,25.
The recommended value for Sweden is 1,5,25.
The tone parameter controls the characteristics of the following call progress
tones:
OL-1267-01
Dial tone
•
•
Busy tone
•
Reorder tone
•
Ringback tone
•
Call waiting tone
A P P E N D I X
Cisco ATA 186 Installation and Configuration Guide
F
F-1