Table of Contents
Advertisement
About Dial Plan Commands
Example 2 (Default Dial Plan)
Cisco ATA 186 Installation and Configuration Guide
D-4
The dial plan:
*St4-|#St4-|911|1>#t8.r9t2-|0>#t811.rat4-|^1t4>#.-
consists of the following rules:
*St4-—If the first digit entered is *, all other dial plan rules are voided. Additional
digits can be entered after the initial * digit, and the timeout before automatic dial
string send is 4 seconds.
#St4—Same as above, except with # as the initial digit entered.
•
•
911—If the dial string 911 is entered, send it immediately.
•
1>#t8.r9t2—If the first digit entered is 1, the timeout before automatic send
is 8 seconds. The terminating character # can be entered at any time to
manually send the dial string. After the 11th digit is entered, the timeout
before automatic send changes to 2 seconds. The user can enter more digits
until the dial string is sent by the timeout or by the user entering the #
character.
0>#t811.rat4—If the first digit entered is 0, the timeout before automatic send
•
is 8 seconds, and the terminating character # can be entered at any time to
manually send the dial string. If the first 3 digits entered are 011, then after
an additional 11 digits are entered, the timeout before automatic send changes
to 4 seconds. The user can enter more digits until the dial string is sent by the
timeout or by the user entering the # character.
^1t4>#.—If the first digit entered is anything other than 1, the timeout before
•
automatic send is 4 seconds. The terminating character # can be entered at
any time to manually send the dial string. The user can enter more digits until
the dial string is sent by the timeout or by the user entering the # character.
Appendix D
Dial Plan Parameters and Defaults
OL-1267-01
Advertisement
Table of Contents
Troubleshooting
