Cisco ATA186-I1 Installation And Configuration Manual page 114

Operating Parameters
Table B-3 Common Operating Parameters and Defaults (continued)
Parameter
SigTimer
StaticIp
StaticRoute
StaticSubNetMask
Cisco ATA 186 Installation and Configuration Guide
B-14
Value
Type Description
Bitmap Controls the timeouts listed.
A 32-bit value is divided into bit fields:
Call Waiting Period (bits 0-7): the
period between each burst of
call-waiting tone. Range=0 to 255 in
0.1 seconds; 0 implies the factory
default value of 100 (0x64=10 seconds)
Reorder delay (bits 8-13): the delay in
playing reorder (fast busy) tone after
far end hangs up. Range=0 to 62 in
seconds, 63=never play reorder.
Default: 5 (seconds)
Ring Timeout (bits 14-19): the amount
of time after which, when there is no
answer, the Cisco ATA 186 rejects the
incoming call. Range=0 to 63 in 10
seconds, 0=never times out. Default: 6
(60 seconds).
No Answer Timeout (bits 20-25): time
to declare no answer and initiate call
forwarding on no answer (used in SIP
only at present). Range=0 to 63 in
seconds. Default: 20 (0x14=20
seconds)
Reserved (bits 26-31).
IP Statically assigned IP address. Used if
the DHCP parameter is set to 0.
IP Statically assigned route. Used if the
DHCP parameter is set to 0.
IP Statically assigned subnetmask. Used if
the DHCP parameter is set to 0.
Appendix B Parameters and Defaults
IVR Access
Code Default
1 0.0.0.0
2 0.0.0.0
10 0.0.0.0
OL-1267-01