Table of Contents
Advertisement
About Using the DHCP Server
Step 1
Step 2
Encrypt Key
About Using the DHCP Server
Cisco ATA 186 Installation and Configuration Guide
3-8
Set the UIPassword parameter to a numeric password by using the web server
interface or TFTP profiling.
You will be prompted for a password when you try to access the web server or a
configurable IVR parameter.
In web server mode, enter the password in the UIPassword field of the
•
password challenge page.
In IVR mode, enter the password, followed by the # key, at the p-a-s-s-w-d
•
prompt.
Encrypt Key encrypts binary files being transferred over TFTP. You can change
this key for each Cisco ATA 186, so that only one particular box can decode the
information. You can change the encrypt key, using the IVR or web interface.
See the
"cfgfmt.exe and ptag.dat Files"
The Cisco ATA 186 polls the server at intervals set in CfgInterval to see if it
needs to be upgraded. You can customize this service. For example, you can route
all calls from a particular Cisco ATA 186, based on the Gatekeeper ID, to an
operator.
DHCP option 60, DHCP_VENDOR_CLASS_ID, is set to the value ATA186 so
that the DHCP server can identify a Cisco ATA 186.
Parameters that you can set using DHCP are:
Client IP address
•
Client Subnet mask—DHCP option 1
•
Routers on the client's subnet—DHCP option 3
•
Domain name servers—DHCP option 6
•
(The Cisco ATA 186 takes up to two DNS servers)
Chapter 3
Configuring the Cisco ATA 186
section for more information.
OL-1267-01
Advertisement
Table of Contents
Troubleshooting
