Honeywell HEN04101(X) User Manual page 87

Figure 3-43 FTP Configuration Interface
2. Click to enable the FTP function.
3. Enter an FTP server address, port, and remote directory.
Table 3-21 FTP Configurations
Parameter
User Name
Password
File Length
Note When the remote directory is null, the system automatically creates folders
according to the IP, time, and channel.
4. Select a Channel and Weekday, then configure up to two Time Periods.
5. Click Test to test the network connection.
A popup message appears to indicate the state of the network connection.
Description
The same user name that you used for logging in to the FTP.
The same password that you used for logging in to the FTP.
This is the upload file length. When the setup is larger than the
actual file length, then the system will upload the whole file.
When the setup is smaller than the actual file length, the
system uploads only the set length, and then ignores
whatever exceeds that length. When the interval value is 0,
then the system uploads all corresponding files.
NVR Configurations | 87
800-18160 - B - 07/2014