Honeywell HEN04101(X) User Manual page 67

Figure 3-25 Schedule Interface
Table 3-10 Schedule Configurations
Parameter
Channel
Week day
Pre-record
Redundancy
Snapshot
Record type
Holiday
Click the corresponding box
return to the previous menu.
Function
Select a channel number. Select All for all channels.
Select a day of the week, or All.
The NVR has a buffer that allows it to "record" video that happens
before an event occurs. Select from 1 to 30 seconds, depending on
the bit stream.
You can configure the NVR to backup recorded files onto two
different HDDs. Click to enable.
Note Before you can enable this function, you must configure at
least one HDD as redundant. Go to Main

Menu Advanced
Note This function is not available if there is only one HDD.
Click to enable the Snapshot function, which takes a snapshot
when an alarm occurs.
Select from: Regular, Motion Detection (MD), Alarm, MD&Alarm.
Click to enable the holiday settings you configured in the General
interface. See Configuring the General Settings on page
to enable each function. Click OK to save the settings and
NVR Configurations | 67

HDD Management).
800-18160 - B - 07/2014
60.