Configuring For Video Loss Detection - Honeywell HEN04101(X) User Manual

178 | Performance Series Network Video Recorder User Guide

Configuring for Video Loss Detection

You can configure the system to generate a video loss alarm when the minimum amount of
video loss (as defined by you) is detected in the video.
Click Video Loss in the Event configuration interface to open the Video Loss configuration
interface.
The configuration for Video Loss Detection is very similar to the configuration for Motion
Detection. Please see
www.honeywell.com/security
Table 5-18
Configuration
Show Message
Send Email
Buzzer
Note Video loss does not support anti-dither, sensitivity, or region setup.
Figure 5-41 Video Loss Configuration Interface
Configuring for Motion Detection on page 174
Motion Detection Configurations
Description
Click to enable a pop-up message on your local host PC
screen to let you know an alarm has occurred.
The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to Main
 
Menu Setting Network
settings. See Configuring Email Settings on page
Click to enable the Buzzer function. When an alarm occurs,
the buzzer beeps.

Email to configure the email
168.
for more information.