Connecting To And Configuring The Remote Devices/Cameras; Configuring The Built-In Switch Setup - Honeywell HEN04101(X) User Manual

Connecting to and Configuring the Remote Devices/Cameras

Depending on your model, your NVR can support up to 16 channels, with a transmission rate of
8Mbps. It supports 100/120 @ 1080p. The delay time for each channel is below 500 ms.
Your NVR supports IP cameras from many popular manufacturers such as Honeywell, Sony,
Hitachi, Dynacolor, Axis, Samsung, Arecont, Dahua, and Onvif. Just enter the camera's URL
address, user name, and password to log in to the camera.
Connect the cameras to the PoE ports on the NVR's rear panel.
The NVR automatically searches for and connects to the network cameras.

Configuring the Built-in Switch Setup

1.
Note You must click Save to save the new settings.
Note The system menu color, language, time display mode, video format, IP address,
and user account will not keep any custom settings if you default the NVR.
Note Do NOT connect the switch to the PoE port. If you do, then the connection might
fail.
Figure 3-52 NVR Real Panel - PoE Ports
Note The four-channel NVR back panel is shown here as an example. The back panel
of the eight-channel and 16-channel NVRs will be slightly different.
Open the Switch Settings configuration interface.
On the Main Menu interface, click Setting
double-click Switch Setting.
NVR Configurations | 109
 
Network Network Setting, then
800-18160 - B - 07/2014