Remotely Configuring Video And Audio - Honeywell HEN04101(X) User Manual

156 | Performance Series Network Video Recorder User Guide

Remotely Configuring Video and Audio

Configuring Encoding for Video and Audio
Click Video&Audio in the REMOTE configuration interface to open the Video&Audio
configuration interface.
www.honeywell.com/security
Table 5-7 Remote - Add Device Configurations
Configuration Description
Delete Select a camera in the Added device list, and then click Delete.
The system disconnects from the camera and removes it from the
Added device list.
Manual Add 1. Click Manual Add, and the Manual Add configuration
2. Select a channel from the drop-down list. Only disconnected
Note
Note
Note
Figure 5-21 Manual Add Configuration Window
interface appears. See Figure
channels are shown.
The NVR supports cameras from Honeywell, Panasonic,
Sony, Dynacolor, Samsung, AXIS, Arecont, Dahua, and
cameras with ONVIF-standard protocol.
If you do not enter an IP address, the system uses the
default IP address 192.168.0.0, and the system does
not connect to this IP address.
You can not add two devices at the same time. If you click
OK, the system connects only to the camera for the
currently selected channel.
5-21.