Honeywell HEN04101(X) User Manual page 105

Table 3-25 Camera Masking Detection Configurations
Configuration
Show message
Alarm upload
Send email
Record channel
PTZ activation
Record delay
Tour
Snapshot
Note You must click Save after configuring the settings to save them.
Note In the Detection interface, the copy-and-paste function is only valid for the same
type of event detection. You can not copy a channel setup in video loss mode to
camera masking mode.
Description
Configure the system to automatically pop up a message in
the local view screen when an alarm occurs.
Click to enable the system to upload the alarm signal to the
network (including an alarm center and the web client). The
system uploads only the alarm channel status.
Go to the Web operation, and then go to the Alarm interface
to set the alarm event and alarm operation. See
Disabling Alarms on page 157
page 184.
The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to Main
 
Menu Setting Network
settings. See Configuring the Email Settings on page
Select a recording channel. See
more about recording.
Not supported.
The system can delay recording for a specified amount of time
after an alarm has ended. Select from 10s to 300s.
Click to enable a tour to be triggered by an alarm. The system
supports 1/8-window tour. Go to
on page 106 for tour interval setup.
Note Tours setup here have higher priority than tours setup
in the Display interface. If there is no alarm, the system
implements the tour setup in the Display interface.
Click to enable the Snapshot function. A snapshot will be
taken when an event occurs.
NVR Configurations | 105
Enabling and
and Configuring Alarms on

Email to configure the email
84.
How to Record on page 94
Configuring Display Settings
800-18160 - B - 07/2014
for