Honeywell HEN04101(X) User Manual page 118

118 | Performance Series Network Video Recorder User Guide
www.honeywell.com/security
Figure 3-62 Abnormality Configuration Interface
Table 3-29 Abnormality Configurations
Configuration
Event Type
Enable
Alarm Out
Latch
Show Message
Alarm Upload
Send Email
Buzzer
Description
Select from No Disk, Disk Error, Disk No Space, Net
Disconnection, IP Conflict, or MAC Conflict.
Click to enable the Abnormality function.
Select an alarm activation output port.
When an event is complete, the system automatically delays,
for a specified time, the NVR from detecting new events.
Click to enable a popup message to alert you when an alarm
occurs.
Click to enable the system to upload the alarm signal to the
network (including an alarm center and the web client). The
system uploads only the alarm channel status.
Go to the Web operation, and then go to the Alarm interface
to set the alarm event and alarm operation. See
Disabling Alarms on page 157
page 184.
The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to Main
 
Menu Setting Network
settings. See Configuring the Email Settings on page
Click to enable the Buzzer function. When an alarm occurs,
the buzzer beeps.
Enabling and
and Configuring Alarms on

Email to configure the email
84.