Cisco Codec C20 Reference Manual page 99

Cisco TelePresence System Codec C20
Contents Introduction
The Video commands
xCommand Video PictureLayoutSet
Select the screen layout mode.
Target: Select if the target is the local layout or the remote layout.
CallId: The CallID is returned when the xCommand Dial command is run. During the call you can run
the xStatus Call command to see the CallId.
LayoutFamily: Select a layout family.
CustomLayoutName: Enter a name for the layout.
Requires user role: USER
Parameters:
Target: <local/remote>
CallId: <0..65534>
LayoutFamily(r): <auto/custom/equal/fullscreen/overlay/presentationlargespeaker/
presentationsmallspeaker/prominent/single/speaker_full>
CustomLayoutName: <S: 1, 128>
example:
xCommand Video PictureLayoutSet Target: Local LayoutFamily: equal
*r SetPictureLayoutResult (status=OK):
** end
xCommand Video Layout SetPresentationView
Set the presentation view mode.
View: Select Default when you want the presentation to be viewed with the default settings for the
codec. Select Maximized when you want the presentation to be displayed in full screen. Select Minimized
when you want the presentation to be displayed in a small picture on screen.
Requires user role: ADMIN
Parameters:
View(r): <Default/Maximized/Minimized>
example:
xCommand Video Layout SetPresentationView View:Default
OK
*r VideoLayoutSetPresentationViewResult (status=OK):
** end
Codec C20 API Reference Guide TC6.0 February 2013.
D14869.05
About the API xConfiguration
99
xCommand xCommand
xCommand Video Layout LoadDb
Loads and starts using the specified video layout database. The default video layout database is
initially provided by the system. The custom database is generated by the Cisco TC Console tool and
is made available to the codec from within the TC Console tool. The TC Console software is found
at the Developer Zone web page. Go to: http://developer.tandberg.com/web/guest/tools/integrators/
audio-console.
Custom: The system uses the custom video layout database which generated by the Cisco TC Console tool.
CustomAutoModes: The system uses the auto mode part of the custom video layout database.
Default: The system use the default video layout database which is provided by the system.
Requires user role: ADMIN
Parameters:
Type(r): <Custom/CustomAutoModes/Default>
example:
xCommand Video Layout LoadDb Type: Default
*r VideoLayoutLoadDbResult (status=OK):
** end
xCommand Video OSD Close
Closes all menus on the on-screen display.
Element: The on –screen menu.
Requires user role: ADMIN
Parameters:
Element(r): <Menu<
example:
xCommand Video OSD Close Element: Menu
*OsdCloseElementResult (status=OK):
** end
API Reference Guide
xStatus Appendices
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.