Cisco Codec C20 Reference Manual page 73

Cisco TelePresence System Codec C20
Contents Introduction
The Boot commands
xCommand Boot
Reboot system.
Action: As a default the system restarts after a reboot. By selecting Shutdown, the system will not restart.
Requires user role: USER
Parameters:
Action: <Restart/Shutdown>
example:
xCommand Boot
*r BootResult (status=OK):
** end
OK
CUIL reboot request, restarting
Connection closed by foreign host.
Codec C20 API Reference Guide TC6.0 February 2013.
D14869.05
About the API xConfiguration
The Call commands
xCommand Call Accept
xCommand Call Reject
73
xCommand xCommand
Accept an incoming call. If no CallId is specified, all incoming calls are accepted. The CallID is returned
when the xCommand Dial command is run. During the call you can run the xStatus Call command to
see the CallId.
Requires user role: USER
Parameters:
CallId: <0..65534>CallType(o): <Audio/Video>
example:
xCommand Call Accept CallId:19
OK
*r CallAcceptResult (status=OK):
** end
Reject incoming call. If no call id is specified, all incoming calls are rejected. The CallID is returned when the
xCommand Dial command is run. During the call you can run the xStatus Call command to see the CallId.
Requires user role: USER
Parameters:
CallId: <0..65534>
example:
xCommand Call Reject CallId:20
OK
*r CallRejectResult (status=OK):
** end
API Reference Guide
xStatus Appendices
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.