Cisco Codec C20 Reference Manual page 79

Cisco TelePresence System Codec C20
Contents Introduction
xCommand Camera Preset Activate
Activate one of the stored camera preset.
Note: The xCommand Camera Preset commands applies to an individual camera. This is in contrast
to the xCommand Preset commands where a single preset covers ALL connected cameras plus the
Video Input switcher settings.
PresetId: The ID of the camera preset you want to activate.
Requires user role: USER
Parameters:
PresetId(r): <1..35>
example:
xCommand Camera Preset Activate PresetId: 1
OK
*r CameraPresetActivateResult (status=OK)
** end
xCommand Camera Preset edit
Edit a stored camera preset. You can change the name of the camera preset and its position in the list
that is returned by the xCommand Camera Preset List command.
Note: The xCommand Camera Preset commands applies to an individual camera. This is in contrast
to the xCommand Preset commands where a single preset covers ALL connected cameras plus the
Video Input switcher settings.
PresetId: The ID of the camera preset you want to edit.
ListPosition: The position in the list returned by the xCommand Camera Preset List command.
Name: The name of the camera preset. It will be used in the list returned by the xCommand Camera
Preset List command.
Requires user role: ADMIN
Parameters:
PresetId(r): <1..35>
ListPosition: <1..35>
Name: <S: 0, 255>
example:
xCommand Camera Preset Edit PresetId: 1 ListPosition: 1 Name: ""
OK
*r CameraPresetEditResult (status=OK)
** end
Codec C20 API Reference Guide TC6.0 February 2013.
D14869.05
About the API xConfiguration
xCommand Camera Preset List
xCommand Camera Preset Remove
79
xCommand xCommand
List information about available camera presets.
Note: The xCommand Camera Preset commands are used to store camera positions for individual
cameras. This is in contrast to the xCommand Preset commands where a single preset stores/recalls
ALL connected cameras plus the Video Input switcher settings. This makes it more usable for integra-
tions where one wants to store multiple camera positions individually per camera rather than a complete
camera position set.
PresetId: Filter on specified preset.
Requires user role: USER
Parameters:
PresetId: <1..35>
example:
xCommand Camera Preset List PresetId: 1
OK
*r CameraPresetListResult (status=OK)
** end
Remove a camera preset.
Note: The xCommand Camera Preset commands applies to an individual camera. This is in contrast
to the xCommand Preset commands where a single preset covers ALL connected cameras plus the
Video Input switcher settings.
PresetId: The ID of the camera preset you want to remove.
Requires user role: USER
Parameters:
PresetId(r): <1..35>
example:
xCommand Camera Preset Remove PresetId: 1
OK
*r CameraPresetRemoveResult (status=OK)
** end
API Reference Guide
xStatus Appendices
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.