Cisco Codec C20 Reference Manual page 34

Cisco TelePresence System Codec C20
Contents Introduction
xConfiguration Conference [1..1] MaxTotalReceiveCallRate
This configuration applies when using a video system's built-in MultiSite feature (optional) to host a
multipoint video conference.
Specify the maximum overall receive bit rate allowed. The bit rate will be divided fairly among all active
calls at any time. This means that the individual calls will be up-speeded or down-speeded as appropri-
ate when someone leaves or enters a multipoint conference, or when a call is put on hold (suspended)
or resumed.
The maximum receive bit rate for each individual call is defined in the Conference MaxReceiveCallRate
setting.
Requires user role: ADMIN
Value space: <64..10000>
Range: Select a value between 64 and 10000.
example: xConfiguration Conference 1 MaxTotalReceiveCallRate: 9000
xConfiguration Conference [1..1] VideoBandwidth Mode
Set the conference video bandwidth mode.
Requires user role: ADMIN
Value space: <Dynamic/Static>
Dynamic: The available transmit bandwidth for the video channels are distributed among the currently
active channels. If there is no presentation, the main video channels will use the bandwidth of the
presentation channel.
Static: The available transmit bandwidth is assigned to each video channel, even if it is not active.
example: xConfiguration Conference 1 VideoBandwidth Mode: Dynamic
xConfiguration Conference [1..1] VideoBandwidth MainChannel Weight
The available transmit video bandwidth is distributed on the main channel and presentation channel
according to "MainChannel Weight" and "PresentationChannel Weight". If the main channel weight is
2 and the presentation channel weight is 1, then the main channel will use twice as much bandwidth
as the presentation channel.
Requires user role: ADMIN
Value space: <1..10>
Range: 1 to 10.
example: xConfiguration Conference 1 VideoBandwidth MainChannel Weight: 5
Codec C20 API Reference Guide TC6.0 February 2013.
D14869.05
About the API xConfiguration xConfiguration
xConfiguration Conference [1..1] VideoBandwidth PresentationChannel Weight
xConfiguration Conference [1..1] PacketLossResilience Mode
xConfiguration Conference [1..1] Presentation Policy
xConfiguration Conference [1..1] Presentation RelayQuality
34
xCommand
The available transmit video bandwidth is distributed on the main channel and presentation channel
according to "MainChannel Weight" and "PresentationChannel Weight". If the main channel weight is
2 and the presentation channel weight is 1, then the main channel will use twice as much bandwidth
as the presentation channel.
Requires user role: ADMIN
Value space: <1..10>
Range: 1 to 10.
example: xConfiguration Conference 1 VideoBandwidth PresentationChannel Weight: 5
Set the packetloss resilience mode. This configuration will only take effect for calls initiated after the
configuration is set.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the packetloss resilience.
On: Enable the packetloss resilience.
example: xConfiguration Conference 1 PacketLossResilience Mode: On
Control how the presentation service is to be performed.
Requires user role: ADMIN
Value space: <LocalRemote/LocalOnly>
LocalRemote: The presentation will be shown locally and sent to remote side.
LocalOnly: The presentation will only be shown locally.
example: xConfiguration Conference 1 Presentation Policy: LocalRemote
Not applicable in this version.
API Reference Guide
xStatus Appendices
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.