Cisco Codec C20 Reference Manual page 94

Cisco TelePresence System Codec C20
Contents Introduction
The Provisioning commands
xCommand Provisioning StartUpgrade
The codec software can be upgraded from the provisioning server. When starting the upgrade the soft-
ware is automatically downloaded and installed. The codec reboots to complete the software upgrade.
Requires user role: ADMIN
example:
xCommand Provisioning StartUpgrade
*r StartUpgradeResult (status=OK):
** end
xCommand Provisioning CUCM CAPF OperationStart
Starts a pending CAPF (Certificate Authority Proxy Function) operation towards the CUCM. When the
CUCM administrator initiates an operation that the endpoint should perform (like installing, updating or
deleting certificates), this command can be used to start the CAPF operation.
AuthString: Set the authentication string required for the CAPF operation.
Requires user role: USER
Parameters:
AuthString(o): >S: 4, 10>
example:
xCommand Provisioning CUCM CAPF OperationStart AuthString: 123456
*r CAPFStartResult (status=OK):
** end
xCommand Provisioning CUCM CAPF Delete
Delete the stored CTL and ITL files (CTL: Certificate Trust List, ITL: Identity Trust List).
Requires user role: USER
example:
xCommand Provisioning CUCM CTL Delete
*r DeleteResult (status=OK):
** end
Codec C20 API Reference Guide TC6.0 February 2013.
D14869.05
About the API xConfiguration
The Security commands
xCommand Security FIPSMode Activate
94
xCommand xCommand
Activate FIPS (140-2) mode. NOTE: Activating FIPS mode implies a reset to factory defaults.
While in FIPS mode, software upgrade is disabled and the following limitations apply: All calls are
encrypted, unencrypted communication protocols like Telnet and HTTP cannot be used. IEEE802.1x
and SNMP are disabled. The SIP Profile Type setting cannot be Microsoft. The root user is not available
(root settings cannot be changed).
To exit FIPS mode, perform a factory reset.
Confirm: <Yes>
Requires user role: ADMIN
Parameters:
Confirm(r): <Yes>
example:
xCommand Security FIPSMode Activate Confirm: "Yes"
OK
*r SecurityFIPSModeActivateConfirmResult (status=OK)
** end
API Reference Guide
xStatus Appendices
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.