Cisco Codec C20 Reference Manual page 95

Telepresence system
Hide thumbs Also See for Codec C20:
Table of Contents

Advertisement

Cisco TelePresence System Codec C20
Contents
Introduction
The Standby commands
xCommand Standby Activate
Set the system in standby mode, which turns off the video outputs and put the camera into sleep mode.
Requires user role: USER
example:
xCommand Standby Activate
*r ActivateResult (status=OK):
** end
xCommand Standby Deactivate
Bring the system out of standby mode.
Requires user role: USER
example:
xCommand Standby Deactivate
*r DeactivateResult (status=OK):
** end
xCommand Standby ResetTimer
Set a nonpermanent standby delay (in minutes). If the system is in standby mode when the reset timer is
set, the system is brought out of standby mode. When left idle for the given delay the system goes into
standby mode. Setting the reset timer does not affect the Standby Delay in the Advanced configuration
menu (or by xConfiguration Standby Delay). Next time this delay is the valid standby delay.
Requires user role: USER
Parameters:
Delay(r): <1..480>
example:
xCommand Standby ResetTimer Delay:10
*r ResetResult (status=OK):
** end
Codec C20 API Reference Guide TC6.0 February 2013.
D14869.05
About the API
xConfiguration
The SystemUnit commands
xCommand SystemUnit OptionKey Add
xCommand SystemUnit OptionKey RemoveAll
xCommand SystemUnit ReleaseKey Add
95
xCommand
xCommand
Add an option key to support additional features.
Requires user role: ADMIN
Parameters:
Key(r): <S: 16, 24>
example:
xCommand SystemUnit OptionKey Add Key:******************
*r OptionKeyResult (status=OK):
** end
Removes all Option keys.
Requires user role: ADMIN
Parameters:
Confirm(r): <Yes>
example:
xCommand SystemUnit OptionKey RemoveAll Confirm: Yes
*r OptionKeyResult (status=OK):
** end
Add the software release key. Used to enable new software (applicable for main software releases).
Requires user role: ADMIN
Parameters:
Key(r): <S: 16, 24>
example:
xCommand SystemUnit ReleaseKey Add Key:******************
*r ReleaseKeyResult (status=OK):
** end
API Reference Guide
xStatus
Appendices
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.

Advertisement

Table of Contents
loading

Table of Contents