Cisco Codec C20 Reference Manual page 97

Cisco TelePresence System Codec C20
Contents Introduction
xCommand SystemUnit DateTime Get
Read the time and date from the system.
Requires user role: USER
example:
xCommand SystemUnit DateTime get
*r DateTimeGetResult (status=OK):
Year: 2009
Month: 7
Day: 3
Hour: 12
Minute: 0
Second: 0
** end
xCommand SystemUnit FactoryReset
Reset the codec to factory default settings. The call logs are deleted and all system parameters are
reset to default values. All files that have been uploaded to the codec are deleted. The Release key and
Option key are not affected.
As a default the system restarts after the factory reset, but other behavior can be forced by selecting
a different TrailingAction.
TrailingAction: Select Shutdown or NoAction to override the default behavior (Restart).
Requires user role: ADMIN
Parameters:
Confirm(r): <Yes>
TrailingAction: <NoAction/Restart/Shutdown>
example:
xCommand SystemUnit FactoryReset Confirm: Yes
*r FactoryResetConfirmResult (status=OK):
** end
Codec C20 API Reference Guide TC6.0 February 2013.
D14869.05
About the API xConfiguration
xCommand SystemUnit SoftwareUpgrade
xCommand SystemUnit ConfigurationProfile Change
xCommand SystemUnit ConfigurationProfile Remove
97
xCommand xCommand
Initiate a software upgrade by fetching the software on a given URL. If the server requires username
and password these parameters must be included.
Requires user role: ADMIN
Parameters:
URL(r): <S: 0, 255>
UserName: <S: 0, 255>
Password: <S: 0, 255>
example:
xCommand SystemUnit SoftwareUpgrade URL: "ftp://<ftp _ server _ ip _ address>/
s52000tc4 _ 0 _ 0.pkg" UserName: testDownload Password: 1234
*r SystemUnitSoftwareUpgradeResult (status=OK):
** end
Select a previously saved configuration profile. NOTE: Requires a restart of the codec.
Requires user role: ADMIN
Parameters:
Name(r): <S: 0, 255>
example:
xCommand SystemUnit ConfigurationProfile Change Name:
"My _ ConfigurationProfile _ 1"
*r ConfigurationProfileChangeResult (status=OK):
Warning: New configuration profile will be active after next boot.
** end
Delete a configuration profile that has been stored in the system.
Requires user role: ADMIN
Parameters:
Name(r): <S: 0, 255>
example:
xCommand SystemUnit ConfigurationProfile Remove Name:
"My _ ConfigurationProfile _ 1"
*r ConfigurationProfileRemoveResult (status=OK):
** end
API Reference Guide
xStatus Appendices
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.