Cisco Codec C20 Reference Manual page 53

Cisco TelePresence System Codec C20
Contents Introduction
xConfiguration SIP Profile [1..1] Type
Enables SIP extensions and special behaviour for a vendor or provider.
Requires user role: ADMIN
Value space: <Standard/Alcatel/Avaya/Cisco/Microsoft/Nortel>
Standard: To be used when registering to standard SIP Proxy (tested with Cisco TelePresence VCS
and Broadsoft)
Alcatel: To be used when registering to Alcatel-Lucent OmniPCX Enterprise. NOTE: This mode is
not fully supported.
Avaya: To be used when registering to Avaya Communication Manager. NOTE: This mode is not
fully supported.
Cisco: To be used when registering to Cisco Unified Communication Manager.
Microsoft: To be used when registering to Microsoft LCS or OCS. NOTE: This mode is not fully supported.
Nortel: To be used when registering to Nortel MCS 5100 or MCS 5200 PBX. NOTE: This mode is
not fully supported.
example: xConfiguration SIP Profile 1 Type: Standard
Codec C20 API Reference Guide TC6.0 February 2013.
D14869.05
About the API xConfiguration xConfiguration
Standby configuration
xConfiguration Standby Control
xConfiguration Standby Delay
xConfiguration Standby BootAction
53
xCommand
Determine whether the system should go into standby mode or not.
Requires user role: ADMIN
Value space: <Off/On>
Off: The system will not enter standby mode.
On: Enter standby mode when the Standby Delay has timed out. NOTE: Requires the Standby Delay
to be set to an appropriate value.
example: xConfiguration Standby Control: On
Define how long (in minutes) the system shall be in idle mode before it goes into standby mode. NOTE:
Requires the Standby Control to be enabled.
Requires user role: ADMIN
Value space: <1..480>
Range: Select a value from 1 to 480 minutes.
example: xConfiguration Standby Delay: 10
Define the camera position after a restart of the codec.
Requires user role: ADMIN
Value space: <None/Preset1/Preset2/Preset3/Preset4/Preset5/Preset6/Preset7/Preset8/
Preset9/Preset10/Preset11/Preset12/Preset13/Preset14/Preset15/RestoreCameraPosition/
DefaultCameraPosition>
None: No action.
Preset1 to Preset15: After a reboot the camera position will be set to the position defined by the
selected preset.
RestoreCameraPosition: After a reboot the camera position will be set to the position it had before
the last boot.
DefaultCameraPosition: After a reboot the camera position will be set to the factory default position.
example: xConfiguration Standby BootAction: DefaultCameraPosition
API Reference Guide
xStatus Appendices
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.