Cisco D9824 Installation And Configuration Manual page 107

Video
Menu Item Description
PV Format Sets the primary video output format for
local decoding.
PV Output Indicates the actual output video format.
This value is read-only.
Stream Indicates the video format of the input
video stream. This value is read-only.
SD Format Selects the standard definition output
format to use on the primary video if the
PV Output is set to SD.
SD Output Indicates the actual standard definition
format of the primary video output if the
PV Output is set to SD.
Bitrate Indicates the bit rate of the input video
stream, in Mbps.
Tri-Synch Select whether to use component Tri-
Synchronization.
Alarm Video Cutoff Sets whether the video output is cut off if
any enabled alarm is active on the receiver.
When video is cut off, there will be no
horizontal or vertical synchronization on
the output. This is useful for downstream
redundancy switching by detecting a loss
of video signal.
Note: This same function also exists under
Setup: Alarm/Warning.
OSD Messages Sets whether alarms and warnings are to
be displayed on the on-screen display (e.g.,
TV monitor).
TV A/R Select the standard definition aspect ratio
of your TV monitor.
Convert Select the conversion method that the
receiver will perform on the incoming
signal for the picture to be displayed
correctly on your TV based on the TV A/R
setting.
Stream Indicates the aspect ratio of the incoming
video stream. This is read-only.
Setup Menu
Parameters
Auto, SD, HD 720p, or HD
1080i
SD, HD 720p, or HD 1080i
Auto, NTSC, PAL-N (AR),
PAL-M or PAL-B/G/I/D. Use
NTSC for 525-line systems and
PAL-B/G/I/D for 625-line
systems.
NTSC, PAL-N (AR), PAL-M or
PAL-B/G/I/D
Enabled or Disabled
Enable or Disable.
The default is Disable.
Enable or Disable
4:3 or 16:9
None, Auto, Auto AFD, 16:9
L/B, 4:3 P/B, 14:9, 4:3 CCO,
16:9 SCALE. The default is
Auto. For more information, see
Aspect Ratio Conversions (on
page 86).
4:3 or 16:9
85