Cisco D9824 Installation And Configuration Manual page 355

Warning Message
Type
ECT Timeout # Set
ECT Timeout # Clear
Memory Usage Set
Host
Memory Usage Clear
Host
Memory Usage Set
Secondary
Memory Usage Clear
Secondary
FPGA Code Set
Version
FPGA Code Clear
Version
Message Cause/Remedy
ECT # is lost Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning.
If the problem persists,
determine if uplink is
sending the current SI
information table.
Disable the warning if
not using the table.
ECT fault cleared –
Excessive Cause: Possible software
(stack/partition)
issue.
memory usage
Remedy: Clear
warnings, reset the unit,
and notify Cisco
Services if the problem
persists.
Normal –
(stack/partition)
memory usage
Excessive Cause: Possible software
(stack/partition)
issue.
memory usage
Remedy: Clear
warnings, reset the unit,
and notify Cisco
Services if the problem
persists.
Normal –
(stack/partition)
memory usage
FPGA newer Cause: FPGA version is
than SW, incompatible with the
Supported=AAA,
software.
Running=BBB
Remedy: Select alternate
FPGA, software
versions, reset unit,
notify Cisco Services if
the problem persists.
FPGA code ver –
OK
Description
No longer receiving
Event Control Table.
–
SW exceeding
allowable memory
usage.
–
Software exceeding
allowable memory
usage.
–
FPGA version is
incompatible with
currently operating
software. You may
encounter operational
difficulties
–
ID
77200
77200
78000
78000
79000
79000
80000
80000
333