Cisco D9824 Installation And Configuration Manual page 132

Chapter 4 Front Panel Operation
Menu Item
UDPPort
SrcPort
Send SAP
SAP Multicast
Address
SAP Port
SAP ID
SAP User Str
FEC
FEC1 UDP
FEC2 UDP
FEC Columns (L)
FEC Rows (D)
110
Description
This selects the destination port
number.
This selects the source UDP
port number.
This selects whether to send
Session Announcement
Protocol messages.
This is the IP address where the
SAP announcements are sent, if
required.
This is the UDP port where the
SAP announcements are sent, if
required.
Describes the SAP output
stream name source.
Provides the SAP user string.
Select the error protection
profile.
For more information, see
Configuring Forward Error
Correction Settings (on page
230).
Enter the destination UDP port
number of the columns FEC
stream.
Enter the destination UDP port
number of the rows FEC
stream.
Set the spacing between non-
consecutive packets used to
calculate the FEC packet.
Set the depth of the FEC matrix. 4 to 20
Parameters
1 to 65534
Note: If you selected RTP for MOIP,
you must select an even destination
port number.
Note: It is not recommended that you
use destination UDP ports reserved
by the IANA.
0 to 65535
Note: Set the SrcPort to 0 to use the
default source UDP port (49162).
None or RFC2327
It is not recommended that you
change the default IP address
(224.2.127.254).
1 to 65534
Note: It is not recommended that you
change the default SAP port 9875.
User String or SDT Channel
Up to 31 characters
1D - Requires generation of one FEC
protecting stream: columns.
2D - Requires generation of two FEC
protecting streams: columns and
rows.
None - Disables the error protection.
Note: For more information, see
SMPTE 2022-1-2007.
2 to 65534, even number only
2 to 65534, even number only
1 to 20