Cisco D9824 Installation And Configuration Manual page 125

TS Out - ASI
Menu Item Description
Name Displays the name assigned to
the transport output for ease of
reference. This is read-only.
Rate Control Select the output rate control.
If the Rate Control is set to
User Rate(Mbps)
User, set the maximum output
bit rate. If null packets are
inserted, this will be the output
rate.
This setting is used when the
signal source is RF or ASI and
allows you to set the output bit
rate to a value expected by
equipment connected to the ASI
output.
Parameters
20-character string
Auto - The output rate follows that set by the
uplink. This setting can be used if the signal
source is ASI. If Insert Null Packet is set to
Yes, the output bit rate is the same as the
input rate (including all the null packets). If
Insert Null Packet is set to No, the output
rate is equal to the payload rate of the
transport stream to be encapsulated, and in
most cases, it will be lower than the overall
input rate.
User - The output rate is specified by the
User Rate (Mbps) parameter. It is
determined by the user setting, regardless of
the input source. Null packets are always
inserted when the configured output bit rate
is higher than the payload rate of the
transport stream to be encapsulated.
0 to 206 Mbps
Note: Output data may be lost if this bit rate
is set to a value less than the actual signal bit
rate.
Setup Menu
103