Cisco D9824 Installation And Configuration Manual page 78

Chapter 4 Front Panel Operation
Menu Item
Link Overflow
MOIP In Redundancy Status
Menu Item
Port In Use
Change Reason
Change Date &
Time
MOIP In IP Source Status
Menu Item
Data1/Data2
Source Host
Data1/Data2 MOIP
Type
MOIP In FEC Status
Menu Item
FEC Rate
CEC
PER
FEC Rows(D)
Present
Col(L)
56
Description
Indicates if the configured output bit rate
(including FEC) is close or higher than the current
Ethernet link speed for the Ethernet port used for
MPEGoIP output.
Description
The current input port in use.
Description of the reason for the last redundancy
status change.
Displays the last date and time the redundancy
status changed.
Description
When locked, this displays the source/host IP
address of the originator. If the signal is not locked,
it will display N/A.
Displays the encapsulation type of transport
stream received from the DATA1 or DATA2 port.
Description
Displays the input stream bit rate, reported by the
FEC decoder.
Indicates the current Corrected Error Count for the
received signal.
Indicates the current Packet Error Rate of the
received signal.
Displays the number of FEC rows.
Displays whether the FEC rows stream is present.
Displays the number of FEC columns.
Parameters
Yes or No
Parameters
Data1 or Data2
None, Setup,
EthLinkStatus, TS
Status, ProgStatus
YYYY/MM/DD
HH:MM:SS
Parameters
UDP or RTP
Parameters
in Mbps
0 to 20
Yes or No
0 to 20