Cisco D9824 Installation And Configuration Manual page 141

5 Use the RIGHT arrow key to move to the right and select PID to display the
detailed menu level.
6 Configure the input to output channel mapping. Video and PCR (Program Clock
Reference) can be output on the same PID or different PIDs. If output on the
same PID, they will appear identical to the input.
Note: If the parameters cannot be saved, the problem may be that the incorrect
Map Mode has been selected. Ensure that Svc ID & PID is selected when
remapping PIDs, otherwise a message such as "Bad configuration data" will be
displayed and you will need to change the parameters to obtain the correct
output.
7 Go to Setup: Outputs, TS Out: ASI, and set the Output Mode to Full DPM
Control. Also, if necessary set the Descramble Mode according to whether the
program is to be Scrambled or Descrambled for downstream
viewing/monitoring.
8 On the same menu, set the following parameters:
Parameter
Map Mode
Duplic Mode
Unref
PSI Options
PSI Rate
Svc ID
9 Set the table parameters as follows:
Parameter
PAT
CAT
PMT
TSDT
NIT
NITO
SDT
SDTO
BAT
EIT
TDT
Description
Svc ID & PID
Pkt Copy
Drop
Ctl By Table
Any
Any
Description
Regen
Regen
Regen
Drop
Regen or Drop
Drop
Regen
Drop
Drop
Drop
Pass
Setup Menu
119