Cisco D9824 Installation And Configuration Manual page 360

Chapter 6 Service and Maintenance
Warning Message
Type
SDI VBI (OP47 Clear
SDP)
SDI VBI (OP47 Set
MDP)
SDI VBI (OP47 Clear
MDP)
SDI VBI (OP47 Clear
MDP)
ETH REDN: Set
Link Speed
ETH REDN: Clear
Link Speed
ETH REDN: Clear
Link Speed
ETH REDN: Clear
Link Speed
MPoIP Bitrate Set
Port #<n>
MPoIP Bitrate Clear
Port #<n>
338
Message Cause/Remedy
Service disabled –
VBI (OP47MDP): Cause: User selection.
configured line
Remedy: Change offset
collides with VII,
for VBI OP47-MDP
service will be
VANC service.
dropped
Line collision –
with VII cleared
Service disabled –
Links speed Cause: Manual
mismatch configuration or auto-
negotiated speed is
detected
different.
Remedy: Make sure link
speed on paired ETH
ports are identical.
Link speeds are –
identical (or not
resolved)
Link speed is not –
resolved
Links speed is –
not monitored in
manual modes
Total configured Cause: Aggregated
output is MPoIP bandwidth on
marginal or too
Port <n> is too high.
high
Remedy: Re-configure
the stream's output rate
to be within 90% of the
link speed on ETH port
<n>.
Total configured –
output is normal
Description
–
VBI OP47-MDP
VANC service is
configured on the line
overlapping with PAL
or NTSC VII line.
–
–
Link speed is different
for two paired Eth
ports. In case of
REDN-controlled
switch this might
trigger overflow on
port with lower link
speed. The condition
for this fault is only
monitored for "auto"
REDN modes.
–
–
–
The configured MPEG
over IP bandwidth is
close or higher than
ETH port <n> link
speed. This condition
can trigger the actual
MPoIP overflow.
–
ID
90050
90060
90060
90060
91000
91000
91000
91000
92000
92100
92000
92100